Wawayanda Flying Club Forum

by **Glitch** » Mon Feb 03, 2014 4:12 pm

Worked on the turtle deck today. Was happy with the finish product.

by **Glitch** » Mon Feb 03, 2014 4:16 pm

Weird.2nd time loading the pictures today. Ok again. This is the finish of the turtle deck to match up with the canopy.

by **Glitch** » Mon Feb 03, 2014 4:18 pm

Put it in twice. :lol:

Oh well. Hopefully tomorrow my sheeting will be here.

by **Glitch** » Wed Feb 05, 2014 7:37 pm

138 hits.......I know somebody is checking out what I am doing. :lol:

With this type weather I'm not going out anyways, so I might as well build. I received my sheeting yesterday so I am trying to finish up with a lot of the little bullshit.
Yip I do believe this Hybrid will fly once more. To think I was getting ready to can it when I thought about it and Caesar asked me if I was going to rebuild it. Here are a few more shots of some of the rear stab I worked on. Also reconnected rudder work.

by **Glitch** » Wed Feb 05, 2014 7:42 pm

repairing rear stabilizer.

by **Glitch** » Thu Feb 06, 2014 1:45 pm

I got little more done today. Installed rudder servo down inside and ran my cables through. Starting to sheet now. Done for today...I'm not feeling very well. Just hope I'm not getting the flue thing

by **Glitch** » Tue Feb 11, 2014 9:44 am

Well after sanding down much of the sheeting it was time to line up for the wing tube, and wing hold downs. Wasn't as bad as a job as I thought it would be but in the process I learned that my wing on one side had some fractures :cry:

More work. So I pulled off the monokote I will start repairing that next. Not much left to do besides cover it, make my hatch hold downs and reinstall my servos and linkages. O yeah I forgot I'll need another pull pull setup. I moved the location of my rudder servo so it made my cables to short. Here is about what I've gotten up to in photos below.

by **Glitch** » Tue Feb 11, 2014 9:54 am

Few more photos. :grin

by **Glitch** » Wed Feb 12, 2014 7:46 pm

Got little more done today. Repairing of the rib root and sheeting on top and bottom.

by **Glitch** » Fri Feb 28, 2014 6:52 pm

Here are a few other things I worked on before getting ready to close it up. For one was making my servo tray for the choke/gas removable. I relocated battery hold down and made mounts to hold fuel tank down.